Files RFP #2019-09 OMIC Additive Manufactuing Center Design Services.pdf Exhibit B.pdf Additional Information Solicitation Number RFP #2019-09 Emerging Small Business Opportunity Only No Notice of Intent of Sole Source No Mandatory Pre-Close Walkthrough 12/06/2019 at 01:00pm OMIC R & D facilities located at 33701 Charles T. Parker Way, Scappoose, Oregon 97056. Check in will be with Michele Vitali, Executive Assistant

Scope of Contract: CLIN 0001 – The contractor shall provide, under line item 0001: 45,000 USG of JET FUEL, AVIATION JA1 (NEAT NO ADDITIVES) (NSN: 9130-00-753-5026) delivered by TANK TRUCK to: 3rd ST MCBH KANEOHE BAY MCBH KANEOHE BAY HI 96863 Required delivery date: December 16, 2019 Delivery will be f.o.b. destination.

The project consists of re-grading the long range and shooting bays as well as replacing target frame holders, and completing site drainage improvements. An additive alternate is included in this bid package for similar improvements to the short range. Sealed bids must be submitted in accordance with the bid documents, drawings and plans, specifications and special conditions related hereto.

The project consists of re-grading the long range and shooting bays as well as replacing target frame holders, and completing site drainage improvements. An additive alternate is included in this bid package for similar improvements to the short range. Sealed bids must be submitted in accordance with the bid documents, drawings and plans, specifications and special conditions related hereto.

The Work includes completion of an existing well hole using cable tool drilling through the existing water bearing zone located at the bottom of the well and by drilling a "rat hole" for debris to collect. The work also includes wellhead piping improvements, other miscellaneous work, and an additive alternate pertaining to a magnetic deviation survey of the uncased portion of the well hole. Estimated cost for the Work is approximately $30,000.

Product Service Code:- 9630 - ADDITIVE METAL MATERIALS NAICS Code:- 331110 - Iron and Steel Mills and Ferroalloy Manufacturing Primary point of contact:- Vanessa Rincon   vanessa.rincon@navy.mil   Phone Number 3012272410 Secondary point of contact:- Zelda Rappuhn   zelda.rappuhn@navy.mil   Phone Number 3012273800

Resurface deck to include a non-slip additive. Testing of skimmers and appurtenances of one (1) “rectangle” shaped pool located at 1155 Douthit Ferry Road; Cartersville GA, 30120. All work/materials must conform and be installed to meet the rules and regulations of “State of Georgia Health Department” as related to public in-door pools.

NASA provides no funding in conjunction with these potential licenses.THE TECHNOLOGY:The Conductive Carbon Nanotube Ink for Inkjet Printing technology combines carbon nanotube inks with other additives, such as metallic nanoparticles, for use in standard inkjet printing.  These inks have resistances in the kilohm range.

Update citations and cross references, make conforming edits and clarifications throughout chapter. 18 AAC 31.010: amend Table A to more clearly describe facility types in each food establishment category. 18 AAC 31.011: adopt federal requirements by reference regarding good manufacturing practices, food additives, labeling, and standards of identity. 18 AAC 31.200: require operators to record date on tag or label when last shellstock from the

As such, NASA developed a robust and simplified additive manufacturing technology to build the nozzle liner outer jacket to close out the channels within and contain the high-pressure coolant.  The new Laser Wire Direct Closeout (LWDC) capability reduces the time to fabricate the nozzle and allows for real-time inspection during the build.