Search results for: cable set modification

This effort would consist of analysis to determine aircraft capability with existing net barrier systems and rollover of deployed cable arresting systems, and limited modification to aircraft to ensure compatibility, if required.Increasing T-7A aircraft endurance via internal fuel tank modification to take advantage of current unused capacity.Implementing Pilot Vehicle Interface upgrades to fully meet 4th/5th generation training needs.

Award Notice

This combined synopsis/solicitation SHALL be posted to SAM Beta (https://beta.sam.gov/).Scope – The Naval Surface Warfare Center, Philadelphia Division (NSWCPD) is seeking sources to fabricate, assemble, and test cable assemblies. The RFQ number is N6449821R4067, attached to this notice. 

order is ;ELECTRICAL,HIGH VOLTAGE SPECIAL PURPOSE CABLE ASSEMBLY; . 2.

SCOPE 1.1 This contract/purchase order contains the requirements for manufacture of the CABLE ASSEMBLY . 2. APPLICABLE DOCUMENTS 2.1 Applicable Documents - The document(s) listed below form a part of this contract/purchase order including modifications or exclusions. DRAWING DATA=7123520 |53711|AE| |D|0001 |AE|49998|8931093 3.

SCOPE 1.1 This contract/purchase order contains the requirements for repair and the contract quality requirements for the CABLE ASSEMBLY,SPEC . 2. APPLICABLE DOCUMENTS 2.1 Applicable Documents - The document(s) listed below form a part of this contract/purchase order including modifications or exclusions. 2.1.1 "Document References" listed below must be obtained by the Contractor.

Riser cable must be installed from the building’s DEMARC into the Tenant’s Data/Communications Room, providing one (1) 25 pair CAT 6 riser cable terminated on a 110-block located on data/telephone backboard (location to be defined by Tenant). d.