This post shall serve as notice that FEMA Region I intends to award a sole source award as detailed in the attached Sole Source Justification. Contact Information: Ryan P. Colgan, Contracting Officer, Phone 6179567529, Email ryan.colgan@fema.dhs.gov Office Address :99 High Street Boston MA 02110 Location: Region I Set Aside: N/A
The Naval Air Systems Command, in support of PMA-261 CH-53 Heavy Lift Helicopters Program Office, intends to solicit a contract for negotiation with Sikorsky, A Lockheed Martin Company, on a sole source basis under the authority of FAR 6.302-1 Only One Responsible Source and No Other Supplies or Services Will Satisfy Agency Requirements, to complete the incorporation of the deployable configuration changes for CH-53K Low Rate Initial Production (LRIP
Rowley Prospect Hill Tank Piping and Valve Configuration Modifications Organization:Town of Rowley Department:RWATER1 - Water Department Location:RWTR1 - Water Department Bulletin Desc:Bid documents may be obtained by contacting Kaitlin Tallman at ktallman@tataandhoward.com.
The Government is conducting market research to identify potential sources that possess the expertise, capabilities, and experience to meet qualification requirements to provide prescriptive data analysis, Engineering and Technical Support Services, Inventory and Configuration Management and Planning and Life-Cycle Forecasting for the F-15 System Program Office.
Configuration or modification of the software to accept a new payment stream (such as a new bill or stub type, payment type, or check/stub processing method, or a new payment processing workflow).
NIH campus wide SCADA system supports its electrical distribution system ranging in voltage from34.5 kV to 208 V that include all the buildings that are in the current SCADA system configuration aswell as any modification or addition to existing SCADA configuration. Building 11 has its ownSCADA and it is excluded from this program.
Develop a procedure to fully document the process for modifying the F-15SA Lighting Trim Panel to yield the -1031 configuration. Develop the precise modification required to migrate the -1027 configuration to become the -1031 configuration. Once created, use the modification procedure to convert one -1027 panel to the -1031 configuration and will use the first article to perform a physical and functional configuration audit (PCA)(FCA).
