Replace existing shingled roof with Ethylene Propylene Diene ARFQ : DOT1800000015 Summary DIVISION OF HIGHWAYS Dusty J Smith Published On : 10/26/17 Amended On : 11/6/17 Closing On : 11/14/17 1:00 PM EST Time Left: 02:10:36 Intent Posted On: Open
Bids shall be submitted in a sealed envelope plainly marked "Bid on Council Chambers Ethylene Propylene Diene Monomer (EPDM) Roof-Bid No. 190141," and show the name and business address of the bidder. BID SECURITY: Bid security in the amount of 10 percent of the bid must accompany each bid in accordance with the Instructions to Bidders.
Added:May 09, 2019 12:12 pm 380 Strips of Ethylene Propylene Monomer (M-Class rubber). Dimensions; eleven inches wide (11"W), ten feet long (10'L), and 3/8 inches thick (.375"D)
Back to searchHomeSearch for Opportunities141031 1000 KCMIL ETHYLENE-PROPYLENE RUBBER (EPR) CABLEOpportunity Bid due in:4 days, 0 hours, 44 minutes, 56 seconds Opportunity Bid is past due141031 - 141031 1000 KCMIL ETHYLENE-PROPYLENE RUBBER (EPR) CABLEStatusStageAmendedPosted3/1/2024Bid Due3/5/2024, 10:00 PM UTCPartner No ContactOrganizationCity of Los AngelesDepartmentWater & PowerNameMCDADE, RASHAWNEmailEmail
141031 - 141031 1000 KCMIL ETHYLENE-PROPYLENE RUBBER (EPR) CABLE Description :- THIS RAMP ID REFERS TO A LOS ANGELES DEPARTMENT OF WATER AND POWER (LADWP) BID OPPORTUNITY. ALL SUBMITTAL REQUIREMENTS ARE NOTED ON THE BID DOCUMENT. BIDS ARE TO BE SUBMITTED ELECTRONICALLY THROUGH THE ELECTRONIC REQUEST SOLICIT PROCURE (eRSP) SYSTEM WHICH CAN BE ACCESSED AT THE LINK SHOWN BELOW. MAIL-IN/HARD COPY BID SUBMITTALS WILL NOT BE ACCEPTED.
Contractor shall prepare concrete roof surface for replacement and install new Ethylene Propylene Diene Monomer (EPDM) roofing system with proper grade and drainage to existing drain on roof.
W91237-24-Q-0027 Contractor shall furnish all personnel, equipment, supplies and material necessary to remove existing roofing and install all components of an Ethylene Propylene Diene Monomer (EPDM) which shall be inspected and warrantied by the manufacturer for materials, wind uplift pressure, thermal movement, and leaking for a period of 20 years.
