Scope Summary Site prep and fabrication, assemble, and installation of a new 50’ x 60’ metal building. This scope assumes existing electrical is still in service to provide power for the new metal building.
Fabricate sheet metal flashing and trim to comply with recommendations in SMACNA's "Architectural Sheet Metal Manual" that apply to design, dimensions, metal, and other characteristics of the item.1. Apron Flashings: Fabricate with lower flange a minimum of 5 inches over and 4 inches beyond each side of downslope asphalt shingles and 6 inches up the vertical surface.2.
Finish flashing and trim with same finish system as adjacent metal panels. 4) Gutters: Formed from same material as roof panels, complete with end pieces, outlet tubes, and other special pieces as required. Fabricate in minimum 96-inch long sections, of size and metal thickness according to SMACNA's "Architectural Sheet Metal Manual." Furnish gutter supports spaced a maximum of 36 inches o.c., fabricated from same metal as gutters.
Finish flashing and trim with same finish system as adjacent metal panels. 4) Gutters: Formed from same material as roof panels, complete with end pieces, outlet tubes, and other special pieces as required. Fabricate in minimum 96-inch long sections, of size and metal thickness according to SMACNA's "Architectural Sheet Metal Manual." Furnish gutter supports spaced a maximum of 36 inches o.c., fabricated from same metal as gutters.
Transportation and supervision necessary to fabricate and install metal materials at all Erie County owned buildings as directed by the County of Erie representative during the contract term. 1001.2- All work must conform to the latest edition of the International Building Code and local laws. 1001.3 - Contract is for a 2-year term from November 1, 2018 to October 31, 2020. 1001.4 - Contractor must be able to provide service 24 hr.
SummaryLeon County is seeking the services of a licensed Building or General Contractor, in the State of Florida as required by Chapter 489, Florida Statutes, to Remove existing roof material; Repair damaged stucco; Install new roof insulation; Install new standing seam metal roof and appurtenances; and Fabricate and Install new metal awnings over exterior doors.Non-Disclosure Agreements can be submitted via e-mail to
Opportunity Summary The Oregon Health Authority, Oregon State Hospital-Junction City (OSH-JC), intends to procure goods and services from a qualified contractor to fabricate and install sheet metal to infill gaps located in three (3) outside areas (the "Project") of the OSH-JC Campus located at 29398 Recovery Way, Junction City, OR 97448.
