Bid Classification: Goods Bid Type: RFT Bid Number: PRC003800 Bid Name: Two (2) Heavy Duty 15” Hand Fed, Drum Style Chippers, Trailer Mounted, with Hydraulic Feed Wheels.
It shall consist of two (2) large-diameter, telescoping, hydraulic lift cylinders, one (1) on each side of the cab, with a frame-mounted electric-over- hydraulic pump for cylinder actuation. Safety flow fuses (velocity fuses) shall be provided in the hydraulic lift cylinders to prevent the raised cab from suddenly dropping in case of a burst hydraulic hose or other hydraulic failure.
Project Description :
of pulling power for each feed wheel) Also includes 10 knife edge teeth on top feed wheel and 16 on bottom feed wheel. 345 degree HAND crank swivel discharge (height adjustable) with 12 inch adjustable chip deflector Clean out and inspection door on discharge 30 inch diameter X 1 1/2/ inch thick (2 knife pocket) chipper disk.
Minimum 235 engine Hp 195 PTO Hp Cab with radio, instructional seat, side and rear sun visor Five rear remote Hydraulic couplers 3 point hitch cat III/IIIN w/adjustable quick coupler 12,000 lb minimum lift capacity Cat III high capacity drawbar with auto – in hammer strap Dual rear wheels and tires single front with R1 radials 50 gpm minimum hydraulic pump capacity Auto guidance ready Weight frame with minimum of 2000 lbs. front weights 1-3/4 1000
Minimum 235 engine Hp 195 PTO Hp Cab with radio, instructional seat, side and rear sun visor Five rear remote Hydraulic couplers 3 point hitch cat III/IIIN w/adjustable quick coupler 12,000 lb minimum lift capacity Cat III high capacity drawbar with auto – in hammer strap Dual rear wheels and tires single front with R1 radials 50 gpm minimum hydraulic pump capacity Auto guidance ready - GPS Weight frame with minimum of 2000 lbs. front weights 1-3/
Required Minimum Specifications Meets Required Specification - Yes/No 12" Throat Capacity Drum Style Chipper Four (4) Knives Engine shall be gas Engine HP should be > 80 HP 360-degree Discharge Chute Height Adjustable End Chip Deflector Two (2) feed wheels with adjustable down pressure springs Hydraulic lift cylinder on the top feed wheel to assist with material feeding and to provide down-pressure Trailer mounted w/ 12-volt DC Electric Brakes and
