Search results for: main rotor blade

REQUIRED CAPABILITIES: The Government requires that contractors be able overhaul/repair the following Composite Main Rotor Baldes: National Stock Number (NSN): Part Number (P/N): 1615-01-690-5019 7-5R0430100-113 1615-01-690-2799 7-5R0430100-107 1615-01-690-4995 7-5R0430100-109 1615-01-690-5029 7-5R0430100-111 1615-01-690-3385 7-5R0430100-103P 1615-01-690-3394 7-5R0430100-105P 1615-01-690-3406 7-5R0430100-101P The Composite Main Rotor Blade is a Critical

The United States Coast Guard (USCG), Aviation Logistics Center (ALC), SRR/MH-65 aircraft division has a requirement for the evaluation and repair of Main Rotor Blades and Main Rotor Blade Tip Caps used on the MH-65 aircraft.

DOWNLOAD BID DOCUMENTS HERE AT NO CHARGE NOTICE TO BIDDERS The DeSoto County Board of Supervisors will receive bids for the purchase of one new Bell helicopter main rotor blade to be used on a Bell 206B3 Jet Ranger helicopter in the following manner: BID FILE NO: 19-201-001 One New Bell Helicopter Main Rotor Blade Pursuant to MS Code 31-7-13 and House Bill 1109, this commodity will be procured through a multi-step procurement process, including

Required delivery shall be FOB Origin.DMWR 1-1615-281, Revision Date 02/10/2012, has been identified for this effort; however, the Main Rotor Blade is a Critical Safety Item (CSI) and is limited only to the approved sources by SRD.

Currently the Main Rotor Blade is and is limited only to the approved source(s) by AED. The following source is listed as an approved source for this effort: Sikorsky Aircraft Corporation, 6900 Main St., Stratford, CT 06614-1378 (CAGE Code 78286).

Forum Drive, Grand Prairie, TX 75052 for Main Rotor Blade Sling for UH-72A Lakota Light Utility Helicopter (LUH). Airbus Helicopters, Inc. is the only company that offers the Main Rotor Blade Sling for this specific model. This sole source requirement meets the conditions of FAR 13.501(a)(2), only one responsible source has been identified as reasonably available to provide the supplies that will satisfy the agency requirements.

. 9)Must be able to hold a main rotor blade that is 22 feet in length. 10)Must be able to hold a tail rotor blade that is 9.5 feet in length. 11)Main Rotor Blade Cuff stand holder must be able to accommodate a blade cuff that is 6 inches wide. 12)Main Rotor Blade Cuff Blade Pin stand diameter hole must be able to accommodate a 1-inch diameter bolt or pin. 13)Main Rotor Blade Cuff stand holder must have a 6-inch spacing to allow the main rotor blade