UOM Requested Delivery P1 GRACO SPRAYER - Model 17Y270 1 EA - Each 23153501 - Paint application system | 5753 $5k, 8425 GRACO SPRAYER, LLV, 200DC, 2A, PBS, LSR P2 Rail system 1 EA - Each 23153501 - Paint application system | 5753 $5k, 8425 Rail system -Airless paint gun -bead gun capable of paint concrete and w beam guardrail -All hose and controls to operate.
Synopsis / Pre-Solicitation This is a Pre-Solicitation notice for a "Additive Manufacturing System" to be procurred as a unrestricted requirement. FOB destination is Tinker AFB OK. No quotes can be accepted until the Solicitation has been posted.Once the solicitation is posted, please make sure all provisions and clauses are appropriately filled in (where applicable), when submitting a quote in.
One year of post-warranty preventive maintenance and repair service is also required.Minimum Technical Requirements - CAR-T cell manufacturing system:1. Shall be a closed and controlled system for manufacturing CAR-T cells from peripheral blood mononuclear cells;2. All process software and tubing hardware necessary for cell enrichment, transduction, wash steps, and expansion;3. Shall include bar code reader;4.
Answer: The Contractor shall quote the typical delivery time for the Compact Hybrid Manufacturing System being offered based on an award issued on or before September 22, 2022.The submission deadline for quotes is UNCHANGED.
Army Corps of Engineers (USACE), Engineer Research and Development Center (ERDC), Geotechnical & Structures Laboratory at Vicksburg, MS has a requirement for the following: Large Format Hybrid Additive Manufacturing System in accordance with the Description of Requirement.
The Ogden Air Logistics Complex (OO-ALC) Innovation Center has a requirement for a Stratasys Fortus 450MC additive manufacturing systems (3D Printers). The 3D Printers are used for the manufacture of polymer plastic parts that meet the specifications for use on aircraft weapons systems.
Iowa State University of Science and Technology (ISU) is soliciting information from qualified Suppliers on behalf of the Material Science and Engineering Department for an Electron Beam Powder Bed Additive Manufacturing System that is fully controllable for a wide range of parameters, including beam trigger control and beam steering/deflection.
