The Contractor shall provide professional-grade, Dedicated Internet Services, transported over fiber optic and delivered through individual fiber optic ports at the CTSEF, as well as Dedicated Internet access using wireless LoS, for the exclusive use of the U.S.
All 120VAC shall meet NEC standards. 8. Conductor sizing and numbers subject to equipment manufacturer recommendations. 3.6 DEDICATED CIRCUIT A. The fire alarm control panel shall be connected to a separate dedicated emergency branch circuit, maximum 20 amperes. This circuit shall be labeled at the main power distribution panel as FIRE ALARM. Fire alarm control panel primary power wiring shall be 12 AWG.
Wall switch sensors must meet NEC grounding requirements by providing a dedicated ground connection and grounding to mounting strap. Line and load wire connections shall be interchangeable. Sensor shall not allow current to pass to the load when sensor is in the unoccupied (Off) condition. 15. Wall switch sensors shall have optional features for photocell/daylight override, and low temperature/high humidity operation. 16.
Provide tamper-resistant in special education and kindergarten, and where required by NEC. 1. Devices: a. 20A- 3W, grd, duplex dedicated outlet Leviton-5263-White b. W.P. lift lid, duplex TayMac-503-S1G, A4 For GFI TayMac S2GA4 c. Ground Fault 20 amp Leviton-6899-White 2. Switches a. 20A switches Leviton-1221-White b. 3-way switches Leviton-1223-White 3. Coverplates a.
Wall switch sensors must meet NEC grounding requirements by providing a dedicated ground connection and grounding to mounting strap. Line and load wire connections shall be interchangeable. Sensor shall not allow current to pass to the load when sensor is in the unoccupied (Off) condition. 15. Wall switch sensors shall have optional features for photocell/daylight override, and low temperature/high humidity operation. 16.
WORKING CLEARANCES FOR ELECTRICAL EQUIPMENT SHALL BE IN COMPLIANCE WITH NEC 110. B. THE EXCLUSIVELY DEDICATED SPACE EXTENDING FROM FLOOR TO STRUCTURAL CEILING WITH WIDTH AND DEPTH OF THE PANELBOARD OR SWITCHBOARD MUST BE CLEAR OF ALL PIPING, DUCTS, EQUIPMENT FOREIGN TO THE ELECTRICAL EQUIPMENT OR ARCHITECTURAL APPURTENANCES IN ACCORDANCE WITH NEC 408. 3.
