BK SOCKET AND MISC ITEMS PURCHASE Solicitation ID/Procurement Identifier: N/A Ultimate Completion Date: Tue Dec 07 18:00:00 GMT 2021
A variation in quantity of +5%/-0% of the total contract quantity is allowed. See FAR 52.211-16 for further details. 5. The resulting award will require NAVY Source Certification. \ 1. SCOPE 1.1 The material covered in this contract/purchase order will be used in a crucial shipboard system.
CDRL: MANUFACTURER SCREW OPERATION SHEET per DI-MISC-80678 e.
Traceability must be maintained through all process operations including any subcontracted operations, to the finished component. 3.15 See CDRL DI-MISC-81020 (Chemical and Mechanical) - Material Certification - In addition to the certification data requirements specified in DI-MISC-81020, the following material certification requirements apply: 3.15.1 Quantitative chemical and mechanical analysis of material is required ;in accordance with MIL-DTL
The required specimens for the Wedge Tensile Test must be separate fasteners from those required for the Yield Test. 3.6.1 Testing for Socket Head Cap Screws must be in accordance MIL-DTL-1222, paragraphs 4.5.2.3 and 4.5.2.3.1. 3.6.2 Testing for all other Headed Fasteners with a nominal diameter greater than 1/4-inch must be in accordance with ASTM-F606 for grades 5, 8, B7, and B16.For all other grades, the following wedge angles must be used. a.
(X) Alternate I Subject to the provisions contained herein, award shall be made to a singleofferor for all subline items within each contract line item. Offers mustinclude each subline item listed within a line item. Failure to do this shallbe cause for rejection to the offer for that particular line item. 6. The resultant award of this solicitation will be issued bilaterallyrequiring the contractor's written acceptance prior to execution. 7.
The required specimens for the Wedge Tensile Test must be separate fasteners from those required for the Yield Test. 3.7.1 Testing for Socket Head Cap Screws must be in accordance MIL-DTL-1222, paragraphs 4.5.2.3 and 4.5.2.3.1. 3.7.2 Testing for all other Headed Fasteners with a nominal diameter greater than 1/4-inch must be in accordance with ASTM-F606 for grades 5, 8, B7, and B16.For all other grades, the following wedge angles must be used. a.
