ITB24-039 HOMER TRANSFER FACILITY LEACHATE TANK REPLACEMENT The Kenai Peninsula Borough hereby invites qualified firms to submit a firm price for acceptance by the Borough for the Homer Transfer Facility Leachate Tank Replacement. The project consists of the removal, replacement, and associated modifications of the leachate storage tank at the Homer Transfer Facility.
to design a redundant power generation system at seven existing water distribution sites, including six elevated storage tank sites and one transfer valve site.
STORAGE TANK & TRANSFER TESTING & MONITORING Agency: Niagara Frontier Transportation Authority Category:Environmental - Commodities Issue Date:06/04/2021 Due Date: 06/25/2021 Ad Type:General
AMENDMENT 0003a 3/30/2022CHANGES TO THE SCOPETitle of the photo labeled "Existing Diesel Fuel Storage Tank & Final Lines" Update to paragraph 2.3.2 "New ATS Requirements"Updated the minimum service rating, minimum manufacturer's warranty, and model number of the suggested Onan automatic transfer switch. 200 Amp minimum rating 208 Volt, 3 PhaseMinimum one year manufacturer’s warranty.Note: Onan OTEC225 fully meets these requirements for Cummins C35D6
The hoses on the discharge side of the pump shall be constructed of heavy-duty EPDM rubber and shall consist of the following lengths and sizes: 1 ½” x 20’ to connect the storage tank to the pump for recirculation, 1 ½” x 25’ to connect truck mounted tanks to the pump for filling. Each hose end that connects to the storage tank shall include female camlock fittings to connect to the mating male camlock fittings.
(V) This combined solicitation/synopsis is for purchase of the following commercial services:CLIN 0001 PURCHASE AND NONPERSONAL TURNKEY SERVICES TO REPLACE GENERATOR FOR EMERGENCY POWER GENERATOR (EPG), AUTOMATIC TRANSFER SWITCH (ATS) AND DIESEL ABOVEGROUND STORAGE TANK (AST) REPLACEMENT LOCATED AT DCO LIHUE, 3260 KAILANI STREET, LIHUE, HI 96766-9702
If the chamber is bolted to a tank up-stand, ensure the bolts are tightened to the correct torque. Sumps shall be tested to manufacturers specifications for vacuum testing. All sumps actively in use (product in the tank and the site is pumping fuel) shall be vented from a minimum of ten (10) minutes before the vacuum test can begin.
