Search results for: vibration and temperature

SUPPLY OF SUPPLY OF VIBRATION AND TEMPERATURE MONITORING SYSTEM Tender Value in ₹:- Should Allow NDA Tender:- No 

The purpose of this Bid is to provide a term contract for Banner Sensor Parts for Vibration and Temperature. Bidders are required to Bid on all items. Please log in to view and download the entire document. This ITB is available for electronic submission in accordance with the instructions identified in the Bid document.

range 80 g peak Amplitude linearity 1% Frequency range - 5%: 3.0 to 5 000 Hz - 10%: 1.0 to 9 000 Hz - 3 dB: 0.5 to 14 000 Hz Resonance frequency, mounted, nominal 30 kHz Transverse sensitivity = 5% of axial Electrical Power requirements - Voltage source: 18 to 30 V DC - Constant current diode: 2 to 10 mA Electrical noise - Broadband: 2.5 Hz to 25 kHz: 700 g - Spectral: 10 Hz: 10 g/vHz 100 Hz: 5 g/vHz 1 000 Hz: 5 g/vHz Output impedance <(><<)> 100

Enclose the equipment in a polyethylene bag or close-fitting airtight container for eight hours at room temperature (70 degrees F minimum).Sample the trapped air and if mercury vapor concentration is 0.01 mg/cu meter or more, the material is mercury contaminated insofar as the requirements of this contract are concerned.

Enclose the equipment in a polyethylene bag or close-fitting airtight container for eight hours at room temperature (70 degrees F minimum).Sample the trapped air and if mercury vapor concentration is 0.01 mg/cu meter or more, the material is mercury contaminated insofar as the requirements of this contract are concerned.

Project Title Remote Vibration Monitoring Project EN22005 Invitation # IFB- RW-22-015 Bid Posting Date 08/22/2022 4:37 PM (PDT) Project Stage Bidding Bid Due Date 10/11/2022 5:00 PM (PDT) Response Format Electronic Project Type Bid Response Types Line Items Subcontractor Bid Bond General Attachment--Bid Package (required) Type of Award Lump Sum Categories 22072 - Temperature Controllers, Indicators, and Recorders (Digital Thermometers, Pyrometers,

How will the vibrations be tested? By LASER interferometer or by experiment? Are there any frequencies that are particularly critical for damping?A4. Laser interferometry.Q5. Is a support frame over the optical table preferred or a a cryostat that mounts from underneath the optical table?A5. A cryostat that mounts from underneath is preferred.Q6. Is there a preference for the coax cable to be used? UT85 SS/SS, UT47 BeCu, UT47 CuNi for example?