UH-60 Tool Kits

THIS IS FOR INFORMATIONAL PURPOSES ONLY. Under the authority of FAR 6.302-1, the Ohio Army National Guard, intends to procure, on a sole source basis, commercial-off-the-shelf tool kits for the UH-60 Helicopters.  The toolkits are manufactured by EEA Tools, LLC (5LNR7).  Based on market research available, EEA Tools, LLC, is the only manufacturer / fabricator of the necessary specialized tools for the UH-60 helicopter heavy maintenance program. EEA Tools, LLCH-60 Basic Kit M/S 70iPart Number: BASICM-60-AAWeight: 105 poundsDimensions: 45”x35”x21” kit box with foam insertsIncludes: main rotor blade alignment tool, main rotor spindle puller, tail rotor pitch beam puller, tail rotor pitch beam nut spanner, tail rotor assembly inspection tool (L/G/S70+,S70 x 2 EA), tail rotor star plate, chip detector removal (2 EA), main module transmission oil filter bowl removal tool L/G/.H-60 Plus KitPart Number: PLUS-60-AAWeight: 100 poundsDimensions: 45”x35”x21” kit box with foam insertsIncludes:

plyon torque adapter (tail), 3/8” drive SAE ¾’ low profile spline torque adaptor, torque adapter set, main module installation tool, flight control bearing press, shaved wall ¼” drive, 3/8” deep well socket, break/strut/damper servicing kit, 2-1/4” socket, main landing gear, with ½” drive adapter, 1”-7/16 ½” drive socket for landing gear strut, main landing gear strut pressure gauge, main landing gear strut torque adapter, tail yoke Teflon washer alignment jig, main rotor retaining nut 20” ½” drive extension, damper spherical bearing press, fixture brace for bifilar weights bolts, 9/16” low profile socket for lower pressure plate bolts, 3/4'” drive, 11/16” socket for main module hardware, torque adapter for pitch change rod, main rotor brushing alignment tool, spindle and blade cuff washer alignment tool, spindle bearing press.All potential responsible sources may submit a response, which if timely received, will be considered by the agency.  This notice of intent is not a request for competitive proposals.  It is a market research tool being used to determine the availability of other qualified sources that can meet the requirements identified above.  The Government is not obligated to and will not pay for any information received from potential sources as a result of this notice of intent.This Notice of Intent is hereby published in accordance with FAR 5.201.  All responses received within 15 days of the posting of this notice, will be considered by the Government.  A determination by the Government not to compete this proposed contract based upon responses to this notice is solely within the discretion of the Government.  Information received will normally be considered solely for the purpose of determining whether to conduct a competitive procurement.Responses may be submitted via email to the contract specialist, Amanda Britton, at Amanda.L.Britton4.civ@mail.mil. THIS IS THE ONLY AUTHROIZED SUMBISSION METHOD.