Shaft Sleeve Machining

NFPC seeks machining services to perform machining services on 70/30 Copper-Nickel (CuNi) shaft sleeves after they have been cast. The finish, tolerance and final dimensions of machining can be found in the below sections, scope of work and applicable documents, with attachments.The material covered in this contract will be used in a crucial shipboard system. The use of incorrect or defective material would create a high probability of failure resulting in serious personnel injury, loss of life, loss of vital shipboard systems, or loss of the ship itself. Therefore, the material has been designated as Special Emphasis SUBSAFE / LEVEL I material and special control procedures are invoked to ensure receipt of correct