CONTRACTOR FIRST ARTIC

CONTINUATION SHEET REFERENCE NO. OF DOCUMENT BEING CONTINUED: CONTINUED ON NEXT PAGE PAGE 5 OF 25 PAGES SPE7M4-24-T-068T SECTION A REPRESENTATION IN PARAGRAPH (c) OF THE PROVISION AT DFARS 252.204-7016, COVERED DEFENSE TELECOMMUNICATIONS EQUIPMENT OR SERVICES – REPRESENTATION. Caution Notice: Offerors are required to comply with domestic material restrictions. The Berry Amendment, the Buy American Act, and other domestic material restrictions may apply. Offerors are instructed to refer to the solicitation clauses related to foreign sourcing for more information on applicability. The Berry Amendment threshold has been reduced to $150,000 and vendors must carefully review related clauses DFARS 252.225-7006, 252.225-7012, and 252.225-7015 for applicability requirements. If your offer is based on a non-domestic material, you are required to provide disclosure information in your quote and/or through written notification to the point of contact listed in the solicitation. DoD Class

Deviation 2023-O0001: A small business joint venture offeror must submit, with its offer, the representation required in paragraph (c) of FAR solicitation provision 52.212-3, Offeror Representations and Certifications-Commercial Products and Commercial Services, and paragraph (c) of FAR solicitation provision 52.219-1, Small Business Program Representations, in accordance with 52.204-8(d) and 52.212- 3(b) for the following categories: (A) Small business; (B) Service-disabled veteran-owned small business; (C) Women-owned small business (WOSB) under the WOSB Program; (D) Economically disadvantaged women-owned small business under the WOSB Program; or (E) Historically underutilized business zone small business. Contractors shall not provide parts and supplies made using additive manufacturing (AM), unless AM is specifically authorized in the solicitation/contract. See procurement note L31. CONTINUATION SHEET REFERENCE NO. OF DOCUMENT BEING CONTINUED: CONTINUED ON NEXT PAGE PAGE 6 OF 25 PAGES SPE7M4-24-T-068T SECTION A Procurement History for NSN/FSC:009837352/4720 CAGE Contract Number Quantity Unit Cost AWD Date Surplus Material . 52529 SPE7M422P3527P00001 8.000 151.69000 20220824 N 63Y25 SPE7M414M4569 42.000 100.78000 20140729 N 00624 SPE7M413M0541P00001 29.000 101.19000 20130808 N 15761 SPM7M412M1786 21.000 103.70000 20120221 N 00624 SPM7M410M3733 42.000 91.65000 20100719 N 3P253 SP074004M6086 51.000 55.20000 20031107 N 0J437 SP074003M6738 50.000 61.85000 20030516 N 0J437 SP074003M6713 59.000 61.86000 20030508 N 0ZBE8 SP074003M6324 50.000 40.00000 20030123 N 0J437 SP074002M6726 27.000 59.48000 20020408 N 0W6H7 SP074001V7127 3.000 94.33000 20010329 N 0ABX5 SP074099V0227 24.000 53.65000 19981013 N 98441 SP074097M2673 34.000 39.27000 19961220 N 7G414 DLA77091MT727 25.000 42.50000 19910930 N 98441 DLA77091MDA85 30.000 25.22000 19910419 N 12920 DLA70088PL667 50.000 27.21000 19880830 N 1G528 DLA70081M0428 104.000 22.06000 19801010 N 00624 DSA70072MMH04 1.000 25.00000 19720308 N 98441 DSA70072D00140013 37.000 9.31000 19720210 N 98441 DSA70072D00140016 3.000 12.35000 19720209 N This solicitation is being issued under the First Destination Transportation (FDT) program to reduce cost of transportation through the use of Government-Arranged Transportation utilizing Government contracts and rates. Offers should be submitted based on FOB Origin. For offerors whose shipments will orginate from outside the contiguous United States, the offeror's FOB Origin price shall include transportation to a contiguous United States location that the offeror selects based on cost effectiveness or other variables at the offeror's discretion. Additional information about FDT can be found at: http://www.dla.mil/FDTPI/ CONTINUATION SHEET REFERENCE NO. OF DOCUMENT BEING CONTINUED: CONTINUED ON NEXT PAGE PAGE 7 OF 25 PAGES SPE7M4-24-T-068T SECTION B PR: 7005355512 NSN/MATERIAL:4720009837352 ITEM DESCRIPTION HOSE ASSEMBLY,NONME HOSE ASSEMBLY,NONMETALLIC FIRST ARTICLE TESTING PER SQAPMIL-DTL-83796 RA001: THIS DOCUMENT INCORPORATES TECHNICAL AND/OR QUALITY REQUIREMENTS (IDENTIFIED BY AN 'R' OR AN 'I' NUMBER) SET FORTH IN FULL TEXT IN THE DLA MASTER LIST OF TECHNICAL AND QUALITY REQUIREMENTS FOUND ON THE WEB AT: http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx FOR SIMPLIFIED ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE SOLICITATION ISSUE DATE OR THE AWARD DATE CONTROLS. FOR LARGE ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE RFP ISSUE DATE APPLIES UNLESS A SOLICITATION AMENDMENT INCORPORATES A FOLLOW-ON REVISION, IN WHICH CASE THE AMENDMENT DATE CONTROLS. RP001: DLA PACKAGING REQUIREMENTS FOR PROCUREMENT RQ011: REMOVAL OF GOVERNMENT IDENTIFICATION FROM NON-ACCEPTED SUPPLIES THIS NSN REQUIRES GOVERNMENT SOURCE INSPECTION WITH A FIRST ARTICLE TEST REQUIREMENT. THE GOVERNMENT SOURCE INSPECTION REQUIREMENT IS VALID ONLY WHEN AN AWARD IS MADE INVOKING THE FIRST ARTICLE TEST REQUIREMENT. IF THE AWARD DOES NOT INCLUDE THE FAT REQUIREMENT, INSPECTION AT DESTINATION IS ACCEPTABLE. "ANY ITEM PREVIOUSLY TESTED BY A VENDOR IN ACCORDANCE WITH *** QUALIFICATION*** REQUIREMENTS (FOR EXAMPLE: FAT, HIGH SHOCK AND/OR VIBRATION TEST), STATED ON DWG, SPECIFICATION, OR STANDARD MAY NOT REQUIRE FURTHER TESTING BY THE SAME VENDOR EXCEPT FOR A LATER CHANGE IN DESIGN, MANUFACTURING PROCEDURES, OR TESTING REQUIREMENTS. A CERTIFICATION OF CONFORMANCE WITH PREVIOUS TEST RESULTS ATTESTING APPLICABILITY SHALL BE SUBMITTED FOR ITEMS PREVIOUSLY TESTED." FULL AND OPEN COMPETITION APPLY RS030: Shelf-life requirement RS001 for a TYPE I (CODE W) item with a shelf life of 120 months (non-extendable) applies to this item. SHELF LIFE MARKINGS REQUIRED PER 5.2.1 OF MIL-STD-129: SHELF-LIFE MARKINGS SHALL BE SHOWN AS PART OF THE ITEM IDENTIFICATION DATA ON UNIT PACKS(>,)> INTERMEDIATE CONTAINERS, EXTERIOR CONTAINERS, AND UNPACKED ITEMS. SHELF-LIFE MARKINGS SHALL INCLUDE THE MANUFACTURED, CURED, ASSEMBLED, OR PACKED DATE (APPLY ONE DATE), AND THE EXPIRATION OR INSPECT/TEST DATE, AS APPROPRIATE. CONTINUATION SHEET REFERENCE NO. OF DOCUMENT BEING CONTINUED: CONTINUED ON NEXT PAGE PAGE 8 OF 25 PAGES SPE7M4-24-T-068T SECTION B CRITICAL APPLICATION ITEM IAW BASIC SPEC NR MIL-DTL-83796/1C(1) NOT 2 REVISION NR C DTD 10/18/2019 PART PIECE NUMBER: M83796/1J320A IAW REFERENCE SPEC NR MIL-DTL-83796B(1) SUP 1 NOT 1 REVISION NR B DTD 10/14/2020 PART PIECE NUMBER: IAW REFERENCE STD NR MIL-STD-129R(3) REVISION NR R DTD 02/25/2023 PART PIECE NUMBER: TYPE 1 SHELF LIFE, 120 MONTHS IAW REFERENCE QAP 16236 SQAPMIL-DTL-83796 REVISION NR A DTD 09/28/2011 PART PIECE NUMBER: CLIN PR PRLI UI QUANTITY UNIT PRICE TOTAL PRICE . 0001 7005355512 0001 EA 24.000 NSN/MATERIAL:4720009837352 DELIVERY (IN DAYS):0114 DELIVER FOB: ORIGIN QTY VARIANCE: PLUS 0% MINUS 0% INSPECTION POINT: DESTINATION ACCEPTANCE POINT: DESTINATION PREP FOR DELIVERY: PKGING DATA - MIL-STD-2073-1E QUP:001 PRES MTHD:AE CLNG/DRY:1 PRESV MAT:00 WRAP MAT:00 CUSH/DUNN MAT:00 CUSH/DUNN THKNESS:0 UNIT CONT:D3 OPI:M INTRMDTE CONT:D3 INTRMDTE CONT QTY:000 PACK CODE:U MARKING SHALL BE IN ACCORDANCE WITH MIL-STD-129. SPECIAL MARKING CODE:32 -32 Type I, shelf life PALLETIZATION SHALL BE IN ACCORDANCE WITH RP001: DLA PACKAGING REQUIREMENTS FOR PROCUREMENT PARCEL POST ADDRESS: SW3113 DLA DISTRIBUTION CHERRY POINT PHANTOM RD BLDG 147 BAY A CHERRY POINT NC 28533-5040 US FOR TRANSPORTATION SEE DLAD DLAD PROC NOTE C19. FOR FIRST DESTINATION TRANSPORTATION SEE DLAD PROC NOTE C20 AND CONTRACT FREIGHT SHIPPING ADDRESS: SW3113 CONTINUATION SHEET REFERENCE NO. OF DOCUMENT BEING CONTINUED: CONTINUED ON NEXT PAGE PAGE 9 OF 25 PAGES SPE7M4-24-T-068T SECTION B PR: 7005355512 PRLI: 0001 CONT’D DLA DISTRIBUTION CHERRY POINT PHANTOM RD BLDG 147 BAY A CHERRY POINT NC 28533-5040 US Need Ship Date:05/14/2024 Original Required Delivery Date:09/02/2024 * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * CONTRACTOR FIRST ARTICLE TEST - THE NUMBER OF UNITS SHOWN SIGNIFIES THE TEST REQUIREMENT. SEE FAR CLAUSE 52.209-3 CITED IN SECTION A OF THIS SOLICITATION FOR THE ACTUAL QUANTITY REQUIRED. CLIN PR PRLI UI QUANTITY UNIT PRICE TOTAL PRICE . 0002 0000000000 EA 1.000 NSN/MATERIAL:0001S00000053 DELIVERY (IN DAYS):0060 THIS LINE ITEM SIGNIFIES THE FIRST ARTICLE TEST REQUIREMENT (FAT). SEE CLAUSES FOR INFORMATION CONCERNING THE FAT REQUIREMENT. OFFERS THAT DO NOT CITE A PRICE FOR THIS LINE ITEM SHALL BE EVALUATED UNDER THE ASSUMPTION THAT THERE IS NO SEPARATE CHARGE FOR THE FAT. IN THE EVENT THE FAT REQUIREMENT IS WAIVED, NO AWARD WILL BE MADE FOR THIS LINE ITEM. THE NUMBER OF UNITS SHOWN APPEARS AS “1 EA”. THIS QUANTITY SIGNIFIES THE TEST REQUIREMENT. OFFERORS WILL FIND THE ACTUAL QUANTITY REQUIRED BY THE GOVERNMENT FOR THE FAT LINE ITEM PER FAR 52.209-3 OR 52.209-4 IN SECTION A OF THIS SOLICITATION. DELIVER FOB: ORIGIN QTY VARIANCE: PLUS 0% MINUS 0% INSPECTION POINT: DESTINATION ACCEPTANCE POINT: DESTINATION Need Ship Date:00/00/0000 Original Required Delivery Date:00/00/0000 * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * CONTINUATION SHEET REFERENCE NO. OF DOCUMENT BEING CONTINUED: PAGE 10 OF 25 PAGES CONTINUED ON NEXT PAGE SPE7M4-24-T-068T