PL4 Alarm Upgrade

 SOURCES SOUGHTThis is a sources sought announcement for market analysis to determine the availability of potential interested vendors. No awards will be made from this notice. No solicitation is available at this time. Therefore, do not request a copy of a solicitation. All responses will be used to determine the appropriate acquisition strategy for a future acquisition. The 27th Special Operations Contracting Squadron located at Cannon Air Force, New Mexico, is seeking sources interested in a possible award to provide a Vindicator Alarm System for Cannon AFB, NM. Please reference the specifications below if interested.The Contractor shall install a new Vindicator Intrusion Detection System (IDS) at Buildings listed in the solicitation.. Corby keypad shall be installed at the entrance, just inside of the door. Installation will include all items as described below, as well as any equipment or items stated or implied in the applicable governing regulations for IDS installation,

certification and monitoring. The Contractor shall install:-As many Passive Infrared (PIR) Motion Sensors to monitor each building listed above as required.-The Balance Magnetic Switches (BMS) for all exterior doors of each building listed above. -All required control cables from the IDS panel to PIR Motion Sensors, and BMS.-GROUND all equipment per industry standards.-Electrical Metal Tubing (EMT) pathways for cabling, core penetration where necessary.-Provide backup battery power to the IDS system in the buildings listed above to allow for a minimum of 4 hour coverage, in the event of power loss.  The Contractor shall provide initial training before acceptance to all personnel identified by the customer, maximum 50 personnel. Training requirements shall be defined by the security system design. The final system design will be approved by the Government prior to installation. All training will take place at Cannon AFB, NM after installation and will be done before final system acceptance. The Contractor will provide the Government all applicable manuals, instructions, and warranties upon final acceptance.If you are interested in providing these supplies to Cannon AFB please send an e-mail to landon.heller@us.af.mil and john.takats@us.af.mil providing the following information about your company: (1) Company Name and Cage Code Number; (2) Mailing Address; (3) Point of Contact to include phone/fax number and e-mail; (4) identify whether your company is small, small disadvantaged, woman-owned, hubzone, 8(a) certified small business concern, service disabled veteran owned, or etc; (5) degree of experience in providing same or similar supplies.Please respond by e-mail no later than 11:00 AM Mountain Standard Time on 28 July 2017 at the above e-mail addresses with the required information. Any capability information received will solely be used for the purpose of market research. All documents associated with this projected requirement will be posted in the FedBizOpps website, https://www.fbo.gov/ as they become available.This is not a Request for Proposal or Invitation for Bid. There is no bid package, solicitation, specifications or drawings available with this announcement. It does not constitute a procurement commitment by the United States Air Force, implied or otherwise. No contract will be awarded from this notice. Responses are strictly voluntary; no reimbursement will be made for any costs associated with providing information in response to this notice or any follow-up information requests. The Government shall not be liable for or suffer any consequential damages for any improperly identified information.Contact Information: Landon Nicholas Heller, Contract Administrator, Phone 5757842876, Email landon.heller@us.af.mil - John M. Takats, Phone 5757842945, Email john.takats@us.af.mil Office Address :110 E. Alison Ave Cannon AFB NM 88103-5321 Location: 27 SOCONS Set Aside: Total Small Business